StewMac Japanese Fret Slotting Saw with Depth Stop

Slots are normally cut to 023 for most fret wire used today Tang measurement varies a bit dependent upon size but it's usually around 116

StewMac Japanese Fret Slotting Saw with Depth Stop They are used for cutting the fret slots in fingerboards and for executing the clean-up pass when cutting inlay pockets The enhanced rigidity of the

Slots are normally cut to 023 for most fret wire used today Tang measurement varies a bit dependent upon size but it's usually around 116

jackpot 123 slot 037 inches The tang height itself, which translates to the fret slot depth, is not listed But if you do the math subtracting the crown height

It shows you if the fret slot will accept the fret wire that you're about to use What you do is put the fret tang up to these two mark lines The lower line is

fret slot saw More often than not the problem was the slot being too shallow for the tang on the fretwire I saw the slots to an appropriate depth when making

Simply hold the flat edge against the fret tang, note the height of the tang against the reference lines, fit the appropriate curved edge into the slot, and